1-3
Getting Started
LAN
† Realtek RTL8100C / 8110S (Optional)
- Integrated Fast Ethernet MAC and PHY in one chip
- Supports 10/100 Mbps (8100C)
- Supports 10/100/1000 Mbps (8110S)
- Compliance with PCI v2.2
- Supports ACPI Power Management
IEEE 1394 (Optional)
† VIA
®
6307 IEEE 1394 controller
- Supports up to two 1394 ports (rear panel x 1, pinheader x 1).
- Transfer rate is up to 400Mbps
Audio
† High Definition link controller integrated in SB450
† Realtek ALC880 8-channel HD audio codec
- Compliance with AC97 v2.3 Spec.
- Meets PC2001 audio performance requirement
On-Board Peripherals
† On-Board Peripherals include:
- 1 floppy port supports 1 FDD with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes
- 1 parallel port supporting SPP/EPP/ECP mode
- 1 serial port
- 1 VGA port
- 2 IEEE1394s (Rear * 1 / Front * 1) (Optional)
- 8 USB2.0 ports (Rear*4/Front*4)
- 1 SPDIF-Out connector
- 1 TV-out header
- 1 Line-In/Line-Out/MIC/Center Speaker Out/Rear Speaker Out/Side Surround
audio port
- 1 RJ-45 LAN Jack
- 2 IDE ports support 4 IDE devices
- 4 serial ATA ports
2.To create a bootable RAID volume for a Windows 2000 environment,
Microsoft’s Windows 2000 Service Pack 4 (SP4) is required. As the
end user cannot boot without SP4, a combination installation CD
must be created before attempting to install the operating system
onto the bootable RAID volume.
To create the combination installation CD, please refer to the fol-
lowing website:
http://www.microsoft.com/windows2000/downloads/
servicepacks/sp4/HFdeploy.htm
To Next Page
Loading...
