Jumpers
JBAT1: Clear CMOS Jumper
There is CMOS RAM onboard that is external powered from a battery located on the
automatically boot into the operating system (OS) every time it is turned on. If you
Keep Data Clear Data
1 1
Important
Afterwards, open the jumper. Do not clear the CMOS RAM while the system is on
because it will damage the motherboard.
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
EnabledNormal
(Default)
(Please enable this
jumper during BIOS
POST.)
Important
Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
bootable.
To Next Page
Loading...
