Chapter 8: Exhaust
82
3. Install the inlet screen cover and tighten the
screws to a torque of 44 in lbs (5 Nm).
4. Clean the gasket material from the air injector
and the muffler. See Figure 8.8.
NOTE: The air injector has a graphite gasket. It
is not reusable. a new gasket must be used
every time.
5. Install the air injector and tighten the screws to a
torque of 62 in lbs (7 Nm).
6. Test run the engine before returning to service.
Figure 8.8
Clean the gasket material
from these surfaces
Graphite gasket
www.mymowerparts.com
For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
