20
5. Digital System Adjustments
The Temposonics measurement systems do not require service or re-calibration under normal use. The systems’
sensing elements are non-contacting and the components are solid state. Performance will not degrade, or drift
over time.
Digital systems have a zero-adjustment only. They do not have field adjustments for scale purposes. The output is
factory set during final calibration by selection of the counter card crystal frequency and zero-preset. If a system
configuration change requires a alternate resolution, the system must be returned to the factory. In some cases,
the customer provided receiver device software may be reprogrammed to adjust to the new settings.
To Next Page
Loading...
Need help?
General