Crankcase Breather 6–09
Diaphragm check
1. Remove cover (5).
2. Take off spring (6), seal (4) and diaphragm (3).
3. Check diaphragm (3) for damage.
4. Replace diaphragm if damaged.
5. Mount diaphragm (3) on housing (2).
6. Install new seal (4) and spring (6) together
with cover (5).
7. Tighten screws of cover (5) to 6 Nm + 2 Nm.
8. Check diaphragms in further oil separators in
t
he same way.
M015560/00E 03-05 ©MTU
To Next Page