6–08 Crankcase Breather
6.3 Crankcase Breather
6.3.1 Crankcase breather – oil separator replacement and diaphragm check
Preconditions
• Engine is stopped and starting disabled.
Special tools
Designation / Use Part No. Qty.
Torque wrench
Spare parts
Designation / Use Part No. Qty.
Filter element
Diaphragm
O-ring
Oil separator replacement
1. Remove cover (2) with O-ring (3).
2. Remove filter element (1) from housing (4).
3. Insert new filter element into housing (4)
observing correct installation position, and fit
cover (2) with new sealing ring.
4. Tighten screws of cover (2) to 6 Nm + 2 Nm.
5. Replace filter elements of further oil separators in
the same way.
M015560/00E 03-05 ©MTU
To Next Page