MI.NET MULTI-NETWORK COLLECTOR
15
Installation and Operation Manual
BATTERY INSTALLATION
NOTE
: Solar installations do not include the backup battery.
Once the collector has been securely mounted, the battery may be installed. While referring to figure 2 and 7, perform the
following steps to install the battery:
1. Remove battery from shipping container
2. Locate and remove battery cable from accessory bag.
3. Attach red battery cable to positive (+) battery terminal and attach the black battery cable to the negative battery
terminal (-).
4. Loosen wing nut screws on battery bracket
5. Place battery bracket in lower position to allow battery insertion
6. Carefully place battery into battery holder pan
7. Very carefully position the battery bracket onto the front corner of the battery. BE VERY CAREFUL –DO NOT ALLOW THE
METAL BRACKET TO TOUCH THE BATTERY TERMINALS! Refer to Figure 2 and 7.
8. Tighten the wing nuts until snug
9. Connect the battery cable connector
Figure 7: Battery Holder and Cable Assembly
IMPORTANT
: To prevent corrosion on the battery terminals, add battery protectant such as Permatex 80370.
To Next Page
Loading...