MI.NET MULTI-NETWORK COLLECTOR
22
Installation and Operation Manual
INSTALLATION CHECKLIST
The installer must perform the following steps.
PRE-INSTALLATION COLLECTOR ITEMS
£ PM / INSTALLER to schedule collector install with Tier 2 at least a day in advance for availability:
(800) 323-8584
£ NOC analyst will review Prop Study to come up with range test locations for PM/Installer
£ NOC analyst to provide locations to PM / Installer for range testing
£ PM / Installer will need DCXR (preferably) or Mi.Node to drive around to Range Test locations for Range Testing
POST-INSTALLATION ITEMS
£ PM / Installer to contact Tier 2 after collector is powered up
£ NOC analyst to verify power levels on collector (message 3.15.1)
£ NOC analyst will verify communication and GPS fix (msg. 3.14.1 Get GPS Status, GPS Fix must be 3)
£ PM / Installer to drive to each Range Test location and call NOC analyst to begin testing
£ NOC analyst to verify signal strength at set locations (msg. 3.1.10 Get Received Signal Strength, RSSI > 40)
Range Test Results Notes
Location 1: |
Location 2: |
Location 3: |
Location 4: |
Location 5: |
£ Once completed, NOC analyst will store in Salesforce for record keeping.
All configuration and control of installed collector units is accomplished remotely, using cellular modem (or Ethernet) based
network links.
To Next Page
Loading...