MI.NET MULTI-NETWORK COLLECTOR
40
Installation and Operation Manual
APPENDIX: COMPLIANCE INFORMATION
FCC INFORMATION
Appendix Changes or modifications not expressly approved by the Mueller Systems could
void the user's authority to
operate the equipment.
IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter
must be installed to
provide a separation distance of at least 34 cm from all persons and must not
be co-located or
operating in conjunction with any other antenna or
transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
IC INFORMATION
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et
d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope
rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
This radio transmitter, IC: 9235A- 2ALEPT0004438, has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain indicated.
To Next Page
Loading...
Need help?
General