Industrial remote access router - RSA-series User Guide – Appendix
Page 23
5
Appendix
Mounting instructions
The units of the RSA series are supplied with a mounting bracket for
symmetrical rails of 35 mm according to DIN 46277-3, BS5584:1978 or
EN 50-022.
To mount the unit on the DINrail, hook the upper side of the DINrail clamp on
the DINrail and then move the lower end housing towards the DINrail until it
latches. Pressing the housing downwards will make the latching easier.
To remove the housing from the DINrail, press the housing downwards while
moving the lower end of the housing away from the DINrail.
Note: For reliable operation over the full temperature range up to +70°C, it
is important that the ventilation slots on top and bottom have free air flow.
To Next Page
Loading...