Industrial remote access router - RSA-series User Guide – Introduction
Page 7
1
Introduction
RSA-1120(W3/W4), RSA-1220(W3/W4)
Industrial DSL/WWAN routers for Remote Site Access.
The MuLogic RSA series of routers is designed for access to
remote locations such as power substations, traffic management
systems and similar remote equipment.
The products are primarily intended for access via ADSL or VDSL2
services while using mobile cellular WWAN networks for back-up,
should the DSL service fail.
The “W3” versions are equipped with an internal 2G/3G cellular
modem, the “W4” versions have a 2G/3G/4G cellular modem.
Features
• Access routers with multiple WAN ports: ADSL, VDSL2, Ethernet and
mobile wireless WAN (WWAN). (Note: depending on model).
• DSL port supports ADSL, ADSL2, ADSL2+ and VDSL2*.
*(RSA-1220 models only).
• One hardware/software version for ADSL Annex A (PSTN overlay) and
Annex B (ISDN overlay.
• ADSL rates: up to 25 Mbit/s downstream, up to 3.5 Mbit/s upstream.
• VDSL rates: up to 100mbit/s downstream, up to 50 Mbit/s upstream.
(RSA-1220 models only).
• Wireless WAN: W3-versions: 2G/3G, 5-Band UMTS, 4-Band GSM.
(Worldwide use).
W4 versions: 2G/3G/4G versions: 5-band LTE, 3-band UMTS, Dual band
GSM. (USA-bands versions available on request)
• ADSL ATM Encapsulation protocols: PPPoA, PPPoE, IPoA, IPoE and
Layer-2 bridging.
• VDSL PTM protocols: PPPoE with or without VLAN ID and Layer 2 bridging.
(RSA-1220 versions only).
To Next Page
Loading...
Need help?
General