Industrial remote access router - RSA-series User Guide – Configuration Acces
Page 17
3
Configuration access
Introduction
The RSA series routers can be configured by means of:
• Web browser interface (HTTP or HTTPS).
• Command line interface (telnet, SSH or RS-232 port*).
Note*: command line access over the serial RS-232 port is possible when the
RS-232 port is set to console mode or CLI mode.
To enable the serial port as console port, keep the reset button pressed while
the power is connected and release the button when the power LED is on.
The serial port will remain in this state until the power is disconnected.
CLI mode can be enabled in the web interface under Tools>Serial CLI
The RS-232 port is of the type DCE and can be connected to a serial port of a
PC by means of a straight male-to-female cable or a USB to RS-232 serial
converter. The data rate and format is 115200 bit/s, 8 bit, No parity.
The factory default access credentials are:
• LAN IP address: 192.168.1.1
• user name: admin
• password: rsa-admin
When in doubt on whether or not these settings are still active and when no
LAN connection can be made with address 192.168.1.1, use the reset button to
restore the factory default settings. (see page 10).
The RSA series web interface allows you to set up, modify, and view
configuration variables and operational data.
Note: To access the web interface in factory default settings, make sure that
the PC’s LAN port is operating on LAN network 192.168.1.0/24
Connect to http://192.168.1.1
Log in with user name admin and password rsa-admin.
After you have successfully logged in, you should see the Device Info
Summary page.
Configuration
interfaces
First time Login
To Next Page
Loading...