User Guide – Introduction Industrial remote access router - RSA-series
Page 8
• Automatic Network Failover operation between DSL, Ethernet-WAN and
Wireless WAN ports.
• Ethernet port supports 10/100baseT, Auto-MDI/MDIX.
All Ethernet port can be used as LAN or WAN port.
• IEEE 802.1Q VLAN support for VDSL2/PTM, LAN and WAN Ethernet
interfaces.
• LAN side Ethernet switch can be configured as Hub for monitoring
purposes.
• Two Serial Port Gateways for remote serial data (TCP/IP or UDP/IP).
• Two serial ports (one RS-232, one RS-485) for data rates from 300 to
115200 bit/s.
• Support for SCADA protocols like Modbus RTU/ASCII, Modbus/TCP,
DNP3, DNP3/IP, IEC60870-5-101and IEC60870-5-104.
• IPsec and OpenVPN tunnels for secure access and data transport.
• OpenVPN bridged (layer 2) and routed (Layer-3) modes.
• GRE tunnels for linking multicast protocols like RIPv2 and OSPF
over IPsec.
• Internal DHCP server, DNS gateway and Dynamic DNS client.
• Static routing and dynamic routing (BGP, OSPF, RIPv1 and RIPv2)
• NAT features: Dynamic NAT (IP masquerading) and NAPT (Port
forwarding)
• Stateful firewall for Access Control, Forwarding control, NAT routing and
port forwarding.
• Device Management: HTTP/HTTPS, Telnet/SSH, SNMP and serial
command port.
• Alerts for system events by means of Email, SNMP traps, SMS, Dry contact
and LED
• Independent watchdog/reset controller for monitoring vital system functions
to guarantee automatic failure recovery.
• Dry contact sensor (input) and dry contact for status/alarm indication and
remote control.
• Isolated supply voltage input for industrial applications (suitable for low
Voltage AC and DC).
• Extended operating temperature range: -40°C to +70°C.
• Rugged metal housing for DIN-rail or panel mounting..
To Next Page
Loading...