Multiplex Icecore 10 R290 User Manual

15
Section 3
COLD CARBONATED UNITS – CONNECTING THE UNIT TO THE WATER, CO2 AND
PYTHON AND COMMISSIONING
1. If the unit is a water cooled version, the glycol module and heat dump must be
installed and connected as detailed in the Glycol module and heat dump installation
guidelines before commissioning the complete system.
 5HPRYHWKHȴOOHUFDSIURPWKHOLGDQGUHGHQGVWRSIURPRYHUȵRZWXEH8VLQJD
IXQQHOȴOOWKHZDWHUEDWKZLWKIUHVKFOHDQFROGZDWHUSUHIHUDEO\EHORZr&XQWLO
ZDWHUMXVWWULFNOHVIURPWKHRYHUȵRZDSSUR[OLWUHV)LWWKHUHGHQGVWRSWRWKH
RYHUȵRZSXVKLQJKRPHWRDFKLHYHDVHDO
 5HSODFHWKHEODFNȴOOHUFDSLQWKHOLG$Q\H[FHVVZDWHUZLOOQRZEHURXWHGWRDQ
LQWHUQDORYHUȵRZDQGZLOOEHHYDSRUDWHGR΍E\WKHUHIULJHUDWLRQV\VWHPYLDWKH
LQWHUQDOERLOR΍WUD\
3. If required, dose the water with the provided biocide control agent in accordance
with the instructions supplied on the bottle, taking note of health and safety
instructions.
4. Connect the mains water supply to the 3\8” John Guest Bulkhead connection
on the right hand side of the unit labelled WATER IN. The mains water supply
should be regulated to a maximum of 50psi and a minimum of 20 PSI pressure is
recommended.
 &RQQHFWWKH&RVXSSO\WRWKH?ȋ-RKQ*XVWEXONKHDGȴWWLQJRQWKHULJKWKDQG
side of the unit labelled CO2 IN.
6. Connect the syrup inlet lines to the syrup coils labelled SYRUPS IN 1-6.
&RQQHFWWKH6RGDUHFLUFȵRZDQGUHWXUQOLQHVZLWKLQWKHS\WKRQWRWKHFRQQHFWLRQV
labelled SODA IN and SODA OUT ensuring these connections are insulated with
VXLWDEOHDUPDȵH[
1 6 5
2 3 4
SYRUPS IN
IN
STILL
5 6 1
4 3 2
SYRUPS OUT
OUT
STILL
OUTIN
SODA

Multiplex Icecore 10 R290 Specifications

General

Brand	Multiplex
Model	Icecore 10 R290
Category	Accessories
Language	English