16 Part Number: 9290312 October/22/2018
Installation Section 2
Connecting the Keg
DANGER
Never stand directly over keg when connecting,
disconnecting, or when keg is pressurized.
Important
Only use AEB Kegs. Available from Manitowoc
Foodservice.
3. First connect the Black quick connect line to the
connection labeled OUT on the coffee keg. This
supplies coffee to Tap 1 and 2.
Important
Hook the OUT line up to the coffee keg first, this helps prime
the system once the nitrogen IN line is connected to the tank.
Pull ring
while
connecting
to post then
release to
lock into
place.
4. Connect the Gray quick connect line second to the
connection labeled IN on the coffee keg. This line
supplies Nitrogen into tank. See “Keg Change” on page
21 & “Priming the System” on page 20
5. The system is now ready to be primed.
6. Press the Prime/Clean button, located in the upper left
corner of the refrigeration cabinet, once to prime the
coffee line. The LED around the button will flash ON
once, then OFF signifying that the Prime function has
been activated.
7. The pump may run for up to twenty (20) seconds while
priming.
NOTE: If priming fails to complete the system will go into
an error state and the Prime/Clean button LED will blink
continuously until the error is cleared. See “Clearing Error
Code” on page 20
8. Once the system is primed it is ready to pour drinks.
9. Check the regulators to make sure the pressures have
not changed and pour a few drinks from each tap to
verify proper flow. Adjust pressures if needed.
10. Check for leaks inside the cabinet and at the taps.
11. Close cabinet door and unit is ready for use.
To Next Page
Loading...
Need help?
General
