26 Part Number: 9290312 October/22/2018
Maintenance Section 4
LEVEL 1 DAILY CLEANING
Cleaning
1. Put on gloves and safety goggles before cleaning unit.
2. Spray each tap with cleaner, wipe down, look for
obstructions, and check for proper flow.
Spray with
cleaner and
wipe
Remove &
wash in sink
3. Drain gate should be removed, interior of drain pan
cleaned, and wiped dry.
4. Wash drain gate in sink and allow to dry.
5. Spray top surface of unit with cleaner and wipe dry.
6. Check interior for any spills or drips, spray with cleaner
and wipe down.
DO NOT Spray
Electronic
Components!
Wipe down
interior surfaces
and any spills
,
Caution
Attention and care should be used to avoid spraying
any electrical component (fans, thermostat and sensor
connections) with any of the fluids.
7. Pull unit out and clean around the cabinet.
Sanitizing
1. Add approved sanitizer to spray bottle mixed to
appropriate ppm concentration and spray all external
surfaces. Allow to remain for 15 minutes, or as directed
by manufacturer, before wiping off.
TAP #1
Surface
TAP #2
Important
TAP #2 Contains an o-ring,
diffuser disc, and diffuser.
2. Spray each nozzle and allow to air soak for 15 minutes,
or as directed by manufacturer, before wiping off.
NOTE: If removing tap nozzles to clean/sanitize, tap 2
contains an o-ring and diffuser. DO NOT lose the diffuser and
make sure it is put back on tap 2 after cleaning/sanitizing.
HOW TO REMOVE NOZZLES
A. Rotate nozzle counter-clockwise by hand, no tool
should be required for removal.
NOTE: Be aware of the diffuser and o-ring in the tap 2 nitro
nozzle. If they are taken out of the nozzle replace in the
correct order as illustrated above.
HOW TO INSTALL NOZZLES
A. To re-install the nozzle, thread the nozzle back
onto the tap by turning clockwise and firmly
hand tighten to prevent leaks, no tool required for
installation.
Important
Coffee on tap 2 will not be nitrogenized properly if the
correct nozzle with diffuser are not installed.
3. Spray internal surfaces and allow to air soak for 15 minutes,
or as directed by manufacturer, before wiping off.
,
Caution
Attention and care should be used to avoid spraying
any electrical component (fans, thermostat and sensor
connections) with any of the fluids.