EasyManuals Logo

Multiplex N2-Fusion ND21TS00 User Manual

Multiplex N2-Fusion ND21TS00
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
34 Part Number: 9290312 October/22/2018
Maintenance Section 4
Interior/Exterior Cleaning, Sanitizing & Rinse
1. Put on gloves and safety goggles before cleaning unit.
2. Spray each tap with cleaner, wipe down, look for
obstructions, and check for proper flow.
3. Drain gate should be removed and interior of drain pan
cleaned and wiped dry.
4. Wash drain gate in sink and allow to dry.
5. Spray top surface of unit with cleaner and wipe dry.
6. Check interior for any spills or drips, spray with cleaner
and wipe down.
DO NOT Spray
Electronic
Components!
Wipe down
interior surfaces
and any spills
,
Caution
Attention and care should be used to avoid spraying
any electrical component (fans, thermostat and sensor
connections) with any of the fluids.
Connect Keg & Prime System
Once all cleaning has been completed the keg can be
reconnected to the system.
Important
Make sure new coffee keg has been chilled to the
operating temperature range of 45° - 36°F (7° - 2°C)
before use or may cause foaming in the system.
See “Keg Change” on page 21
Close cabinet door and unit is ready for use.
LEVEL 3  MONTHLY CLEANING
In Place Keg Cleaning
Perform the a weekly cleaning on all six (6) store kegs, three
(3) product and three (3) cleaning. This can be performed
during the weekly cleaning once a month.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Multiplex N2-Fusion ND21TS00 and is the answer not in the manual?

Multiplex N2-Fusion ND21TS00 Specifications

General IconGeneral
BrandMultiplex
ModelN2-Fusion ND21TS00
CategoryBeverage Dispenser
LanguageEnglish

Related product manuals