Part Number: 9290312 October/22/2018 33
Section 4 Maintenance
Keg Connector Cleaning
1. If keg is not disconnected, then do so and set keg aside.
n
Warning
NEVER ATTEMPT TO REMOVE KEG LID WITHOUT FIRST
DE-PRESSURIZING KEG!
Pull ring to
release from
post
2. Spray cleaner on one keg connector and wipe down
with clean towel.
3. If required a brush can be used for stains or residue
build-up.
4. Repeat Step 1 and 2 for other keg connectors.
Keg Connector Sanitizing
• Frequency: Every week or as required.
1. Mix proper concentration of approved sanitizing
solution in clean bucket and place keg connectors into
bucket and allow to soak for 15 minutes , or as directed
by manufacturer.
NOTE: An alternative method is to heavily spray both
of the connectors with sanitizing solution and allow
sanitizer to remain for fifteen (15) minutes or as directed by
manufacturer.
2. Once keg connectors are cleaned and sanitized each
one should be immersed into clean water for at least
five (5) minutes for rinsing.
To Next Page
Loading...
Need help?
General
