WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20) — PAGE 25
LINKAGE CHECK
Check and make sure that all linkages within the buggy are
functioning correctly.
DUMP CYLINDER CHECK
1. Check the power buggy’s dump cylinder as outlined in
the maintenance section of this manual.
2. Make sure that both Zerk fittings for the dump cylinder
have been lubricated.
HYDRAULIC OIL CHECK
1. Visually read the hydraulic sight glass (Figure 11) to
see if the hydraulic oil level is low.
2. If the hydraulic oil is low, add enough hydraulic oil to
bring the oil level to a normal, safe operating level.
Figure 11. Hydraulic Sight Glass
NORMAL
OPERATING
LEVEL (HOT)
INSPECTION
To order go to Discount-Equipment.com
To Next Page
Loading...
