MULTIQUIP WTB-16PD - Page 31

WTB-16PD TRACK-DRIVE POWER BUGGY • OPERATION MANUAL — REV. #0 (08/31/20) — PAGE 31
OPERATION
SHUTDOWN (NORMAL)
Correct shutdown is important for safe operation. Follow
these general steps:
1. Come to a full stop.
2. Place the parking brake knob in the ON position
(brake set).
Figure 23. Brake Knob (ON Position)
3. Verify that the parking brake lamp is lit (ON).
Figure 24. Parking Brake Lamp (ON)
4. Place the throttle lever (Figure 15) in the slow position.
Idle the engine 3–5 minutes for gradual cooling.
5. Place the ignition switch key in the OFF position.
OFF
ON
P
A
R
K
I
N
G
6. Place the fuel valve lever (Figure 25) in the OFF
position.
Figure 25. Fuel Tank ON/OFF Valve (OFF)
7. Cycle the hydraulic controls to eliminate residual
pressure.
8. Remove the ignition key.
EMERGENCY SHUTDOWN
This power buggy is equipped with a safety kill switch. This
switch is located on the right side of the handlebar.
1. Push the EMERGENCY STOP switch (Figure 26).
Figure 26. Emergency Stop Switch (Push)
OFF
OFF
FUEL
EMERGENCY
STOP
SWITCH
PUSH
To order go to Discount-Equipment.com