Multitech MT2834ZDX - Command Group: Data Compression and Error Correction; Data Compression Settings; V.42 Error Correction at 300 bps

4 AT Commands, S-Registers, and Result Codes
41
Command: &E n Non-Error Correction Mode Flow Control
Values: n = 10 or 11
Default: 10
Description: &E10 Disable non-error correction mode flow control.
&E11 Enable non-error correction mode flow control.
Command: &E n Pacing (Computer-Initiated Flow Control)
Values: n = 12 or 13
Default: 13
Description: &E12 Pacing disabled.
&E13 Pacing enabled.
Command: &E n Data Compression
Values: n = 14 or 15
Default: 15
Description: &E14 Data compression disabled.
&E15 Data compression enabled.
Command: $E n V.42 Error Correction at 300 bps
Values: n = 0 or 1
Default: 0
Description: $E0 V.42 error correction at 300 bps disabled.
$E1 V.42 error correction at 300 bps enabled.
Command: $EB n Asynchronous Word Length
Values: n = 0 or 1
Default: 0
Description: $EB0 10-bit mode enabled.
$EB1 11-bit mode enabled.