A Regulatory Compliance
81
CTR21*
This equipment has been approved by Commission Decision CTR21 for
pan-European single terminal connection to the public switched telephone
network (PSTN). However, due to differences between the individual PSTNs
provided in different countries, the approval does not, of itself, give an un-
conditional assurance of successful operation on every PSTN network termi-
nation point.
In the event of problems, you should contact your equipment supplier first.
Australian Modem Warning Notice
Modems connected to the Australian telecommunications network must have
a valid AUSTEL permit. This modem has been specifically configured to
ensure compliance with AUSTEL Standards. The following commands can
affect compliance and must not be set outside the permissible range.
Modem Commands
Command Default Permissible Range
A: Do not use —
ATB B0 Do not change
AT&G &G2 Do not change
AT&P &P1 Do not change
ATSn
see table below —
S-Register Default Permissible Range
S6 4 2–5
*Applies only to the MT2834ZDXIe model.
To Next Page
Loading...
