A Regulatory Compliance
79
Compliance with BABT Requirements
Approved for connection to telecommunications system specified in the in-
structions for use subject to the conditions set out in them.
Warning: Interconnection directly, or by way of other apparatus, of ports
marked “SAFETY WARNING see instructions for use” with ports marked or not
so marked may produce hazardous conditions on the network. Advice should
be obtained from a competent engineer before such a connection is made.
Telephones that connect to the external socket must be approved for direct
connection to the Public Switched Telephone Network (PSTN).
This apparatus has been approved for the use of the following facilities:
• Auto-calling
• Loop disconnect and MF dialing
• Phone number storage and retrieval by a predetermined code
• Operation in the absence of proceed indication
• Automatic storage of last number dialed
• Tone detection-busy
• Auto clear from the originating end
• DTR dialing
• Modem
• PBX timed break register recall
Any other usage will invalidate the approval of the apparatus if, as a result, it
then ceases to comply with the standards against which approval was granted.
To Next Page
Loading...
