4 AT Commands, S-Registers, and Result Codes
51
Command: #S
y
Enter Setup Password
Values:
y
= password (6–10 characters)
Default: MODEMSETUP
Description: Enters the remote configuration setup password.
Command: #S=
y
Store Setup Password
Values:
y
= password (6–10 characters)
Default: MODEMSETUP
Description: Stores a new remote configuration setup password.
Command: T Tone-Dial
Values: n/a
Default: P command
Description: Modem will tone-dial numbers following a T in
the dialing command.
Command: &T
n
Respond to Remote Digital Loopback Signal
Values:
n
= 4 or 5
Default: 5
Description: &T4 Enable response to remote digital loopback
signal.
&T5 Disable response to remote digital loopback
signal.
Command: #T
n
Trellis-Coded Modulation
Values:
n
= 0 or 1
Default: 1
Description: #T0 Disable trellis-coded modulation.
#T1 Enable trellis-coded modulation.
To Next Page
Loading...
