Multitech MultiConnect Cell 100 series - Mounting Device to Flat Surface; Device Mounting Procedure

INSTALLING AND USING THE DEVICE
MultiConnect
®
Cell MTC-MNK1 User Guide 15
Note: If you send AT#SHDN and do not remove power, the radio restarts after 60 seconds.
Mounting Device to Flat Surface
1. Locate the groove on the bottom of the device.
2. Slide the mounting bracket through the groove.
3. To secure the bracket to the desired surface, place and tighten two screws in the holes on either end of
the mounting bracket. The dimensions illustration in this guide shows the mounting bracket, as well as
the dimensions for placement of the screws.