Multitech MultiConnect Cell 100 series - FTP File Download from Server; Download Initiation and File Type; Reading Text Messages; Text Message Mode Setup

CONFIGURING AND COMMUNICATING WITH YOUR DEVICE
24 MultiConnect
®
Cell MTC-MNK1 User Guide
AT#FTPOPEN="###.##.###.#","username","password",0
where ###.##.###.# is the IP address and the username and password for the FTP server.
6. Configure file transfer type.
Enter:
AT#FTPTYPE=#
where # is 0 for binary or 1 for ASCII.
7. If required, change the working directory to "folder1".
Enter:
AT#FTPCWD="folder1"
8. Enter the file name.
Enter:
AT#FTPGET="filename.txt"
where filename.txt is the file to download.
The device responds with:
CONNECT
The file is received through the device. The device responds with:
NO CARRIER
The data connection closes automatically when the file sending ends.
Closing the FTP Data Connection
After the file is sent:
1. Close the FTP connection.
Enter:
AT#FTPCLOSE
2. Close the PPP data connection.
Enter:
Verizon:
AT#SGACT=3,0
Other Networks:
AT#SGACT=1,0
The device responds with OK.
Reading, Writing and Deleting Messages
Reading Text Messages
NOTE: For CAT M1 devices, you can only send/receive SMS messages from other CAT M1 devices on the same
network.
To read a text message in text mode:
1. Send a message to the phone number of the currently installed SIM.
2. Put the device in text mode.
Enter:
AT+CMGF=1