2–2
The two blowers inside the HC-150 spin very quickly. Your hand may
be hurt if you put it inside a blower while it is turning. Keep your hands
away from the blowers while the unit is turned on. Do not run the HC-
150 unless both the process and reactivation fans are protected by
ductwork or finger guards.
There are two conditions which could cause the unit to start without
warning:
•When the Auto/Off/Manual switch is set to Auto, the unit may start
if the humidistat contacts close.
• The motors on the blowers have internal over-current protection.
If one of these blowers is overloaded, the affected motor will turn
itself off. This over-current protection will reset automatically, so
the blower may start without warning.
You can avoid either kind of problem if you turn off the power before
working on the unit.
This type of wheel is washable. It is best to clean the wheel using clean
water only. If you must use a detergent, choose a mild type (enzyme
or dish-washing detergent). The wheel is sensitive to high pH (alkaline
condition). Choose a detergent with a neutral pH. Do not use any
solvent to wash the wheel.
PLEASE READ ALL OF THIS MANUAL. PLEASE FOLLOW THE INSTRUCTIONS
CAREFULLY AND COMPLETELY. PLEASE PAY PARTICULAR ATTENTION TO THE
SAFETY INSTRUCTIONS AND PRECAUTIONS.
To Next Page
Loading...
Need help?
General
