Munters HC-150 - Suggested Replacement Parts List

5–6
gent). The wheel is sensitive to high pH (alkaline condition). Choose a detergent
with a neutral pH. Do not use typical laundry detergents. Do not use any solvent to
wash the wheel. This will permanently damage the wheel.
11. If the wheel is still plugged, or if the honeycomb structure has softened, please call
the Service Operations Department at Munters.
12. To replace the wheel, reverse Steps 2 through 6 above.
5.11 SUGGESTED REPLACEMENT PARTS
Note - For part numbers, see the electrical parts list attached at the end of this manual.
Noncritical Critical
Part Appl. Appl.
Desiccant wheel 11" dia. x 200 mm ....................... 1
Seal kit ................................................................... 1
Drive subassembly for desiccant wheel
(Model HC-150R) ................................................... 1 1
Drive subassembly for desiccant wheel
(Model HC-150I)..................................................... 1 1
Belt for desiccant drive wheel ................................ 1 1
Process air filter ..................................................... 1 1
Reactivation air filter............................................... 1 1
Reactivation heater (Model HC-150R)
1ø, 1.5KW, 115V .................................................... 1 1
Reactivation heater (Model HC-150I)
1ø, 3KW, 230V ....................................................... 1 1