6.3 Serviceoptions
In addition to commissioning of the unit there are four service options (A - D) as standard.
S. Commissioning/start-up.
A. Inspection and if necessary chang e of filter. General function check.
B. In addition to A, safe ty check and capacity, temperature and humidity regulation measurements.
C. In addition to B, preventive replacement of some components after 3 years of operation.
D. In addition to C, preventive replacement of some components after 6 years of operation.
NOTE!
Always contactMunters forservice orrepair. Operating faults canoccurifthe unit ismaintained
insufficientlyorincorrectly.
NOTE!
Commissioning/Start-up inspection"S"by Munters ismandatory tovalidate thefullwarranty.
Munters service engineers have special equipment and rapid spare parts access to handle ser vice on all
Munters products. All test equipment used by our personnel to ensure proper system balancing is cer tified
for accuracy.
Munters Service can offer a service plan adapted to suit the conditions of a specific installation. See contact
addresses on t he back page of this manual.
The service options comprises service efforts indicated in Table 6.1 and T able 6.2.
6.4 Extendedwarranty
Munters o ffers an extended warranty to the standard terms when the Customer signs a service contract with
Munters. Details are ava ilable on request.
6.5 Serviceindicatorlamp
The yellow ser vice indicator lamp indicates one of the following:
■
Filter replacement required
■
Humidity level too high
■
Ser vice requirement s
The reason for the ser vice alarm is shown on the control system display.
38
Serviceandmaintenance
190TEN–1089–G1412
To Next Page
Loading...
