EasyManuals Logo

Muratec MFX-3091 Quick Start Guide

Muratec MFX-3091
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
- 50 -
Scanning to E-mail
4
Scanning
Memo
If conguring a small network consisting of only your
machine and a computer, set IP addresses as shown
below (according to RFC1918).
For the computer
IP address : 192.168.0.1~254
Subnet mask : 255.255.255.0
Default gateway : not used
DNS server : not used
For the machine
IP Address Set : Manual
IPv4 Address : 192.168.0.1~254
(select a different value
from the computer)
Subnet Mask : 255.255.255.0
Gateway Address : 0.0.0.0
Network Scale : Small
To set [Network Scale], press the <SETTING> key
and then select [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Scale].
1 Prepare an Ethernet cable and a hub.
Prepare an Ethernet cable (category 5, twisted
pair, straight) and a hub separately.
2 Hold down the power switch for
approximately one second to turn off the
power.
3 Plug one end of the Ethernet cable into
the network interface connection on the
back of the machine.
4 Plug the other end of the Ethernet cable
into the hub.
5 Hold down the power switch for
approximately one second to turn on the
power.

Table of Contents

Other manuals for Muratec MFX-3091

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Muratec MFX-3091 and is the answer not in the manual?

Muratec MFX-3091 Specifications

General IconGeneral
BrandMuratec
ModelMFX-3091
CategoryAll in One Printer
LanguageEnglish

Related product manuals