- 97 -
Printing from a Computer
5
Printing
4 Plug the other end of the Ethernet cable
into the hub.
5 Hold down the power switch for
approximately one second to turn on the
power.
6 Press the <SETTING> key on the
operator panel.
7 Press the to select [Easy Setup], and
press
OK
.
8 Enter the administrator password.
The factory default password is “aaaaaa”.
a Press , , , to select the
character you want, and then
press
OK
.
- The selected character is entered as “*” in
the text eld.
- If you have entered an incorrect value,
press the <CLEAR> key and then enter
the correct value.
b Repeat step a until all characters
required are entered.
c Press the and to select [Enter]
and press
OK
.
9 Press the to select [Network
Setting], and then press the .
10 If setting the IP address manually, check
that [Manual] is selected, and press
OK
.
If obtaining the IP address automatically, press
the to select [Auto], and press
OK
. Proceed to
the step 15.
To Next Page
Loading...
Need help?
General
