Section 40 00-02-0994
2016-06-28 - 22 -
Setting MPC-20 to Stop the Engine from Utilizing the Countdown Timer
The MPC-20 will control the running of the engine until the chosen stop condition is met or until the countdown
timer runs out of time. Once set, the operator will be required to disable or change the timer in order to eliminate
the countdown timer being active on every startup.
1. Access Menu/Start_Stop Timers/Countdown Timer.
3. Set the hours, minutes and seconds desired for the running of the engine, and press [Enter].
4. Press the [Menu] key to leave the Menu Setup screens.
Screen Examples
To Next Page
Loading...