Section 40 00-02-0994
2016-06-28 - 28 -
Menu Glossary
System
Date/Time: allows the setting of the controller’s date and time.
Pressure Units: allows the selection of psi, kPa or BAR for pressure designation.
Factory set to PSI.
Temperature Units: allows the selection of Fahrenheit or Celsius for temperature designation.
Factory set to
Fahrenheit.
Level Units: allows the selection of Feet or Meters for level designation.
Factory set to Feet.
Flow Units: allows the selection of gal/min (US), gal/min (UK) and lpm (Liters Per Minute)for flow designation.
Factory set to gal/min (US).
Brightness: allows the backlight of the screen to be adjusted.
Factory set to 90.
Contrast: allows the contrast of the screen to be adjusted.
Factory set to 150.
Backlight Control: turns off (disables) or on (enables) the screen’s backlight.
Factory set to Enable.
Beeper: turns off (disables) or on (enables) the alarm beeper for the controller.
Factory set to Enable
Standby Timer: setting this timer (HH:MM:SS) allows the screen the designated amount of time before the
controller goes into Standby mode.
Factory set to 00:30:00.
Service Reminders: when the service reminder is set to 0, the alarms will be disabled. However, the countdown
will continue and will show the numbers as (-) numbers as it counts down past 0 for the following parameters:
All
service reminders factory set to 250 Hrs.
Oil Life
Oil Filter Life
Belt Life
Battery Life
Fuel Filter Life
Air Filter Life
Overhaul Life
Reset All
Stored Fault Codes: allows the operator to query the Engine ECU for review of its stored fault codes.
Auto / Manual: allows the controller to power up in either Manual or Auto Mode of operation depending on the
selection chosen.
Factory set to Manual.
Restore Factory Defaults: allows the operator to reset all menu settings set as defaults from the last
configuration loaded in the controller.
View Alarm History: allows the viewing of stored alarms.
Clear Event History: allows the clearing of stored events (alarms).
ECU Diagnostic Mode: puts the ECU in Diagnostic Mode.
Clear ECU Fault Code: clears the stored faults in the ECU but you must have it in ECU Diagnostic Mode.
To Next Page
Loading...