Section 40 00-02-0994
2016-06-28 - 46 -
Specifications
Electrical
Display: 3.8” monochrome, transflective, white backlight LCD with heater
Operating Voltage: 8-32 VDC, protected against reverse battery polarity and load-dump
Power Consumption: 18W max without 2 2A High-sides active, 146W max with 2 2A High-sides active
Communications
2-CAN: J1939 (only one supported in initial release)
USB: 2.0B (only supported for programming)
Ethernet: (not supported in initial release)
RS485: Modbus RTU
Connection: Delphi SICMA 90-way connector
Keyboard: 11 tactile feedback buttons
Inputs
6-Digital Inputs: configurable (high/low)
8-Analog Inputs: configurable (4-20mA, 0-5V, resistive)
1-Frequency Input:
supporting Magnetic Pickup:
(2 Hz – 10 kHz, 3.6 VAC – 120 VAC)
Supporting Engine Alternator:
(2 Hz – 10 kHz, 4.5 VRMS – 90 VRMS)
Outputs
6-Relays: 10A, SPDT, Form C (30 VDC @ 10A max.), 40A maximum aggregate @ 85C
2-Low-side Outputs: 1A
2-High-side Outputs: 2A
2-5V Outputs: 200mA (to drive external relays)
1-Analog Output: 0-5V
Real-time clock: with battery backup
Environmental
Operating Temperature: -40°F to 185°F (-40°C to +85°C)
Storage Temperature: -40°F to 185°F (-40°C to +85°C)
Protection: IP67 front and back, panel seal is IP66 when used with accessory gasket
Emissions: SAE J1113
Immunity: SAE J1113
Vibration: Random vibration, 7.86 Grms (5-2000 Hz), 3 axes
Shock: ± 50G in axis
Mechanical
Case Material: Polycarbonate/ABS
Keypad/Gasket Material: Silicone
To Next Page
Loading...