Section 40 00-02-0994
2016-06-28 - 39 -
starting and stopping on flow. 0 gpm must be selected in the maintain flow for the steady/proportional
features to work. Factory set to Steady.
Deadband Flow. This extends above and below the maintain set point, no throttling occurs while the flow
in the deadband. Factory set to 0 gpm.
Flow Maintain Type. In / Out. Empty / Fill. In starts on low, stops on high. In throttles by increasing the
RPM below the deadband and decreasing the RPM above the deadband. This is opposite of Out.
Factory set to Out.
Flow P. Allows adjustment if using PID throttling Factory set to 0.020
Flow I. Allows adjustment if using PID throttling. Factory set to 0.020
Flow D. Allows adjustment if using PID throttling. Factory set to 0.001.
Temperature Transducer
Start Temperature. When the temperature drops to this set point, an auto start will occur.
Factory set to 32 F
Stop Temperature. When the temperature rises to this set point, an auto stop will occur.
Factory set to 32 F.
Warnings and Shutdowns
High Level Warning. Factory set to 0.0 ft.
High Level Shutdown. Factory set to 0.0 ft.
Low Level Warning. Factory set to 0.0 ft.
High Flow Warning. Factory set to 0 gpm.
High Flow Shutdown. Factory set to 0 gpm.
Low Flow Warning. Factory set to 0 gpm.
Low Flow Shutdown. Factory set to 0 gpm.
High Discharge Pressure Warning. Factory set to 0.00 psi.
High Discharge Pressure Shutdown. Factory set to 0.00 psi.
Low Discharge Pressure Warning. Factory set to 0.00 psi.
Low Discharge Pressure Shutdown. Factory set to 0.00 psi.
High Suction Pressure Warning. Factory set to 0.00 psi.
High Suction Pressure Shutdown. Factory set to 0.00 psi.
Low Suction Pressure Warning. Factory set to 0.00 psi.
Low Suction Pressure Shutdown. Factory set to 0.00 psi.
High Pump Housing Temp. Warning. Factory wet to 32 F.
High Pump Housing Temp. Shutdown. Factory set to 32 F.
High Pump Oil Temp. Warning. Factory set to 32 F.
High Pump Oil Temp. Shutdown. Factory set to 32 F.
Start / Stop Timers
This section allows the setting of the timers to start and stop the engine. There are eight timers, each with a Start
Day and a Stop Day, a Start Time and a Stop Time.
Countdown Timer: The countdown timer will be active upon every auto startup until the time is changed or
disabled. It is used when it is desirable for a machine to run for a specific amount of time unmonitored and then
shut itself off when that time has expired or when an alternate Stop condition has been met. Format of
HH:MM:SS.
Start / Stop Timer (1-8): Each of the eight timers contains the ability to select from the following parameters:
To Next Page
Loading...