Installation
User manual 59719_hdb_en_12 38 / 65
6 Installation
WARNING!
High electrical voltages
Electric shock may cause life-threatening injuries.
Only an electric installer is allowed to connect the device!
Before performing work at the device, disconnect it from the voltage
source.
Observe five safety rules!
Protective measures
during connection work
According to IEC 60364 - Protection against electric shock
CAUTION!
Hot surface
Burnings and line damage caused by touching the devices.
Wear thermally suitable protective gloves.
Only use lines with a temperature resistance of at least 80 °C.
6.1 Connection lines
WARNING!
Risk of fire due to short circuit!
Supply lines and/or modules damaged by short circuit can cause overheating
and fires!
Provide intelligent current monitoring or fuse.
NOTE
The cable length of the sensor and actuator cables is limited to 30 m.
To Next Page
Loading...
Need help?
General
