A3 Scanner User Manual (PC)
29
Calibrator
Contents and Requirements
Contents Checklist:
Before proceeding, please insure that all of the
contents from the list below have been included in
your package.
1. A3 Scanner User Manual
2. IT8 Target Image Color Card
If anything from the list above is missing or damaged,
please contact customer service to have it replaced.
System Requirements:
Pentium III Processor or higher
CD-ROM Drive
Windows XP/Vista/7
24-bit Video Card (or higher)
At least 256MB RAM
Minimum 150 MB available hard drive space
Introduction
Using the Calibrator
The Calibrator is a color calibrating program
provided with your scanner. It allows you to adjust
the color of the scanned images so that the
appearance of the image closely matches the colors
of your original document.
All of the Calibrator’s functions are contained in easy
to use graphical interfaces based on the traditional
Windows format. Calibrating the scanner (or
scanner plus transparency adapter) is a simple task
that takes only minutes to complete.
About the Target Image
The target image included with this package is to be
used to create a scanner profile. The target image is
very important and must be handled with care, or the
calibration of your scanner may be adversely affected.
Calibrator
Chapter Three
3
To Next Page
Loading...
