then measure the resistance in the method stated.
3. Capacitance range: Turn the range to the capacitance position; insert the test probes and disconnect the two
metal probes; observe the reading on the LCD, and press the “REL” button if there is an initial reading; the “▲”
symbol appears on the LCD screen. The initial reading is “000” (Vary in different ranges), and then measure the
capacitance in the method stated.
• Some ranges are subjected to interference. It is normal that the reading is not reset or changes in a
small range after the relative value measurement is enabled.
• After the measurement is completed, pay attention to the relative value measurement status.
To Next Page
Loading...
Need help?
General
