Automatic measurement of waveform
The multimeter can automatically measure the amplitude and frequency of the current waveform, and the
measurement results are displayed in the right side of the waveform display area.
The waveform measurement is the effective value directly sampled by the multimeter A/D.
Press the “DIS” button to display a stable waveform on the LCD.
Holding and saving signal waveform
The main purpose of holding waveform is to hold the current waveform for closer observation. Save the current
waveform when you need to save it in the database.
Method of holding waveform: Press the "HOLD" button, the waveform is held/stored; H0~H9 are displayed in
the lower right part of the LCD screen, indicating the order in which the 10 waveform groups are stored.
To Next Page
Loading...
Need help?
General
