Holding and saving measurement data
The measurement can be held and saved with a single button. When the “HOLD” button is pressed, the reading
being displayed will be saved (This function cannot be used when there is no input in the frequency range), and the
icon “H00~H99” for data storage will appear on the LCD screen. Press the “HOLD” button again to resume normal
operation. However, the data is already stored in the internal memory.
1. To save the current measurement to the database, press the “HOLD” button to save this data.
2. After the data is held, hold down the “HOLD” button for 2 seconds to enable the database function, which can
display the saved data.
3. When the meter is in the data hold state, press “HOLD” to exit the data hold state; press and hold the “HOLD”
button to display the stored data.
4. When the range is switched or the measurement function is changed, the hold status is automatically disabled.
To Next Page
Loading...
Need help?
General
