MUSTOOL MT8206 - Page 26

22
Continuity test
Warning!
To avoid electric shock, do not test the continuity on the line carrying voltage.
1. Insert the connecting plug of the black test probe into the
negative COM jack; insert the connecting plug of the red test
probe into the positive resistance Ω jack.
2. Rotate the function switch, point the arrow on the knob to
the Ω Cap range, and press the “SELE” button to
switch to the range.
3. Contact the circuit under with test probes. If the resistance is
lower than 50Ω, the buzzer will beep.
Diagram of continuity test