MUTOH Ultima 850 - Performing a Test Cut

Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions
48
AP-75125, Rev 1.3 ; 20/10/04
5.5. PERFORMING A TEST CUT
In order to enable the user to check if the cutter is fully functional, without needing a computer, Mutoh
Europe has integrated four demo test cuts into the Ultima cutters.
Following demo cuts are accessible by pressing the [TEST] key.
→
Cut test
→ SC-850 or SC-1400
→
Quality check
→
Knife offset
→ Test
→
Settings plot
→
EPOS Align Tune (Manual)
→
EPOS Align Tune (Automatic)
→
EPOS system
→ check sensor
→
Test sheet verify epos alignment