MUTOH ValueJet 1638 - Replacing the Cutter

AP-76943_Rev 1.0 Page 17/19
8 Replacing the cutter
(1) Replacement frequency
Replace the cutter when the following situation occurs:
 When the media is not cut smoothly
 When the cut surface is feathered, etc.
(2) Replacing steps
Step 1: If the printer is powered ON, make sure that printing or other operations are not in
progress.
Step 2: Display the CR Maintenance menu.
 Press the [Menu] key.
 “Menu1: Setup>” is displayed.
 The operation panel shifts to the Setup menu display.
 Press [>].
 “Set1: User Type” is displayed.
 Press [+] or [–] to select “Set20: CR Maintenance”.
 Press [Enter].
 “CR Mainte.: Start” is displayed.
 The display enters the CR Maintenance menu.
Step 3: Press [Enter].
 Maintenance starts.
 The print head moves to the left of the printer (cutter replacement position).
 “CR Maintenance: End” is displayed.
Step 4: Open the maintenance cover at the left side of the printer.
Note
 Replace the cutter in a short time.
Leaving the print head at the cutter replacement position for a long time may
result in clogging of the print head. Please limit to 15 minutes.