14
In case connection is not automatically initiated after a few seconds, you can connect
from the Bluetooth device or by pressing “on” for 4 seconds.
5.1. Affiliation reset function
You can remove all affiliated devices from the system memory. This operation is not
reversible; right after resetting, you will have to repeat the affiliation procedure for
the cell phone (or for other compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
Press “on” and keep it pressed (for more than 4 seconds), until the LEDs start to
flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up
mode”;
Press “” and “” at the same time for 4 seconds, and release them when you
hear a beep. The N-Com will emit a special acoustic signal to confirm and will then
turn itself off.
To Next Page
Loading...
