25
14. “UNIVERSAL INTERCOM”
The N-Com Bluetooth Kit3 PLUS system can be connected via Bluetooth to intercom
systems of other brands, thanks to the UNIVERSAL INTERCOM function.
14.1. Pairing up the UNIVERSAL INTERCOM
To pair up an N-Com system and an intercom of another brand (from now on called
Intercom B), the following procedure needs to be carried out:
Put the N-Com system in the “Pair up Mode” by pressing the “on” key for
more than 4 seconds, until the LEDs start to flash quickly;
Put Intercom B in the pair up mode of a mobile phone (please refer to the
manual of your specific Intercom B for additional information).
Briefly press the “on” key on the N-Com system; after a few seconds, the
two systems will “recognize” each other and an acoustic message will
indicate that the pair up procedure was successful.
To turn on the audio between the two helmets, press the “on” key on the N-
Com system.
14.2. UNIVERSAL INTERCOM function
After properly carrying out the pair up procedure, turn on both systems.
To turn on and off the audio between two helmets, proceed as follows:
1. FROM THE N-COM SYSTEM: press “on” on the N-Com system. Intercom B
receives an incoming call tone to which you need to answer with the call
answering button (please refer to the manual for Intercom B). To turn off the
intercom, briefly press the “on” key again.
2. FROM INTERCOM B: press the “Vocal Call” command. The N-Com system will
receive an incoming call tone. To turn off the intercom, press the “Vocal Call”
command again
To Next Page
Loading...
Need help?
General
