20
11. N-COM RIDER-PASSENGER INTERCOM MODE
In order to use Bluetooth Kit3 PLUS in wireless intercom mode, both helmets have to
be equipped with a Bluetooth kit.
In order for two Bluetooth Kits to communicate with one another, they have to be
paired up first.
11.1. Intercom affiliation
1. Make sure both N-Com Bluetooth systems are turned off;
2. Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more
than 4 seconds), until the LEDS start to flash quickly;
3. On either one of the two helmets, press “on” briefly;
4. After a few seconds, the helmets “recognize” each another, a beep is emitted to
signal the pair up was successful and intercom communication is activated;
5. Turn off both N-Com Bluetooth systems and turn them back on to store the pair
up data.
11.2. Intercom function
After carrying out the proper pair up procedure, turn on the two helmets. Intercom
connection will be established automatically (this will take a few seconds. Wait until
you hear the vocal confirmation message).
If automatic connection is not possible, proceed with the manual connection.
Manual intercom activation
With Bluetooth Kit3 PLUS turned on, briefly press
“on”.
Manual intercom
deactivation
With Bluetooth Kit3 PLUS turned on, briefly press
“on”.
To Next Page
Loading...