22
13. N-COM BIKE-TO-BIKE INTERCOM
The N-Com Bluetooth Kit3 PLUS system is used for bike-to-bike communication up to
a distance of about 500 m (open terrain, no obstacles).
N.B.: The range and quality of the communication may very significantly depending
on the presence of obstacles, weather conditions, magnetic fields.
N.B.: The range of the communication varies depending on the N-Com systems used.
The Bluetooth Kit3 PLUS system stores up to 4 different Bluetooth Kit3 PLUS systems,
so that “calls” can be made to these devices.
So that two Bluetooth Kit3 PLUS systems can communicate with one another in the
Bike-to-Bike mode, they must be paired up first.
13.1. Bike-to-Bike pair up
1. Make sure both N-Com Bluetooth Kit3 PLUS systems are turned off;
2. Set both N-Com Bluetooth Kit3 PLUS systems in Pairing up mode by pressing
“on” (for more than 4 seconds), until the LEDS start to flash quickly;
3. On Helmet 1 press the “memory” button where you wish to store Helmet 2;
Position Button Confirmation beep
A 2 sec. 2 acute beeps
B 2 sec. 2 grave beeps
C 4 sec. 4 acute beeps
D 4 sec. 4 grave beeps
N.B.: If the selected memory setting is taken, you will hear an error beep after which
a different combination must be entered.
4. After a few seconds, the helmets “recognize” one another: a confirmation
beep is given in Helmet 2 that indicates the memory setting where Helmet 1
is stored and Intercom communication is established;
To Next Page
Loading...