Adjustments and Status LEDs 4-13
Rev. 9-09-16 Part #C-00084
www.NabcoEntrances.com Magnum 4A Control Wiring and Adjustment Manual
Potentiometer Description
TDAS
(Time Delay Activating Signal)
Determines how long door will stay open after activation (or input signal) is released.
and
Full Automatic door
Low Energy door
Event Action
adjustment.
X
X
X
X
stay open.
TDPG
Full Automatic door
Low Energy door
Event Action (Full Automatic doors)
adjustment after door is pushed.
X
X
X
stay open.
X
operators that use a clutch gear, Push n Go is only active from the fully closed position
once the door is manually pushed out of latch position.
X If Push n Go is desired for all door positions, a clutchless operator must be ordered.
(Not used on
Full Automatic door
Low Energy door
Event Action
adjustment.
X
X
X
(Not used on
Full Automatic door
Low Energy door
Event Action
adjustment.
X
X
X
Adjusts how hard the door will push against an obstacle (while opening) before recycling.
X
X
adjustments are made to the door and door operation is satisfactory.
To Next Page
Loading...
Need help?
General
