Connect Incoming 120 VAC Wires 5-15
Rev. 9-09-16 Part #C-00084
www.NabcoEntrances.com Magnum 4A Control Wiring and Adjustment Manual
Disconnect 120 VAC power prior to making any electrical connections. Failure to
do so may result in serious personal or fatal injury. When uncertain whether power
supply is disconnected, always verify using a voltmeter.
Notice: Wiring must meet all local, state, federal or other governing agency codes.
Ensure all power is disconnected.
All high voltage electrical connections must be made by licensed electricians.
a.
Keep all Incoming 120 VAC wiring separate from low voltage wiring within Header.
a.
To Next Page
Loading...
Need help?
General
