BATTERY INSERTION PROCEDURE
1 Insert a hooked tip into the battery door release hole.
2 Slide out the battery tray.
3 Place the supplied CR2025 battery into the tray. Ensure the "+" symbol is
facing upwards.
4 Slide the tray back until it clicks into place.
REMOTE CONTROL
1 ON: Switch D 7050 from Standby mode to operating mode.
2 OFF: Switch D 7050 to standby mode.
3 +/- : Increase or decrease volume level. Release mute function.
IMPORTANT NOTES
• The volume level increment is by 0.5dB. However, the display screen can only show 2 digits and thus
cannot include the 0.5dB increment change.
• The rst press of “+” or “-“ will not display any change in volume level as this is the 0.5dB increment
change. It is by the second press of “+” or “-“ wherein the volume level display will show an increase or
decrease by 1dB.
• Press and hold either “+” or “-“ and the volume level will increase or decrease by 3dB increments.
4 t u: Select source.
5 uj : Temporarily mute audio or restore audio from mute mode.
6 Applicable for Airplay mode and for Tuner Controls of NAD products with Tuner section
AIRPLAY MODE
uj : Pause or resume playback of current song; if applicable, pause or resume broadcast.
For Apple devices, allow 10 seconds delay before pressing uj again to resume playback.
9 : Skip backward to previous song; if applicable, scan backward through current broadcast.
0 : Skip forward to next song; if applicable, scan forward through current broadcast.
TUNER CONTROLS (Not applicable for D 7050; Applicable for NAD products with Tuner section)
9 0 : Step up or down Presets.
uj : Select through applicable Tuner bands.
IDENTIFICATION OF CONTROLS
1
3
2
5
6
4
9
To Next Page
Loading...
